Recent content by 1989comanche

These were just under $100.00

Finally fixed the toe it was off almost 1/2?. Then finished installing the headlights and new bezel.

[thumbsup] Hung flagthen came home fixed tire. these are pretty handy to have.

Mo pics

Anyone out there know if XJ skids are compatible with mj ? Or can be modified easily. Or do I just have to build something from scratch??  There isn't much out there to look at. [weld]  [weld]

Anyone out there know if XJ skids are compatible with mj ? Or can be modified easily. Or do I just have to build something from scratch??  There isn't much out there to look at. [weld]  [weld]

Brown Santa brought me new steering parts. Time for the install. First measured the lengths of the parts so I could duplicate them. Measured from zerk fitting to zerk fitting. That way I could get within a 16th of each other. Didn't take any pics of that. Don't have three arms. Then disassemble...

The alternator in my Comanche has taken a dump. I think it is only an 85 amp. What is the highest amperage that will bolt in? What was it originally in? I would like to upgrade to support a winch and more lighting

HAPPY THANKSGIVING EVERYONE. Have a great day [thumbsup]

??? Does anyone know what color vaccum line is supposed to do what on a 89 MJ. There are 4 tubes  if my studying is right one is the vacuum source one vent line and one for engage axle one for disengage. I think I have a broken line somewhere. I have checked the actuator on the axle it is...

:) Happy Father's Day to all the dads out there

:-[ I am trying to find a Trans mount for 1989 Comanche 4.0 5 speed. I guess I have a Peugeot Trans. I found it on Quqdratech but am hoping to grab one at a local parts store. Does anyone out here have the same part on your rig? If so what rig do you have. When I look up my vehicle all the...

Anyone planning on going to Pomona tomorrow?

??? ??? My power steering has been acting up. Some days it works fine some days not so good. It has been driving me nuts trying to figure it out . Some days it wouldn't kick in till after you were above 1500 rpm so driving in a parking lot was a bear. Next day everything was fine. So I replaced...

???  I have a infiniti qx4 with the 3.5 motor. It ingested one of the power valve butterfly screws. So I have pulled the motor, taken care of the screw stuck to piston problem. Now I have the motor back in and reinstalled. Now I have been trying to get it to start. Spins over but doesn't light...