bty34's latest activity
-
Bbty34 replied to the thread All your Rubicons are belong to us! .What's going on with the missing hardware on the sliders?
-
Bbty34 replied to the thread Jeffro06's 2006 Rubicon.Hmm, looks awful familiar.
-
Bbty34 replied to the thread Bty34 TJ Build.I'm pretty happy with how the heights matched up after the flanging tool. It was a lot quicker than all the test fitting it would have...
-
-
Bbty34 replied to the thread Parting out a TJ.5.38 with arbs. I'd probably steal one of the arbs to stick in the rear 60 in the other Jeep, assuming they're 35 spline. It's too bad...
-
Bbty34 replied to the thread Parting out a TJ.Good eye. I thought he said full traction, but you're right, that does look like Rubicon Express. He's down to $7500 for it, which...
-
-
BThere's a TJ nearby that has caught my interest. Being from NY, it looks like it was used mostly in the mud. It doesn't look in too bad...
-
-
Bbty34 replied to the thread Bob's boring build.When I talked to them about my heims losing the liners within 500 miles, they said it was the first time they had ever heard of it.
-
Bbty34 replied to the thread Bty34 TJ Build.Decided to flange the front section rather than butt weld. Pretty well test fit and ready to start prepping for welding.
-
-
Bbty34 replied to the thread Bty34 TJ Build.Modified the rear brace for the skid with another piece of angle I had laying around. Also added 1/2" of drop in the center. The...
-
-
Bbty34 replied to the thread Bty34 TJ Build.It's just a flat piece of 3/8 6061 and some spacers at the frame rail. The aluminum portion on the Savvy fit with the Atlas, but the...
-
-
Bbty34 replied to the thread Bty34 TJ Build.Pulled the bolts out of the rear stiffener. The aluminum plate is bent, but pretty minimal. I might loosen the top bolts on the...
-
-
Bbty34 replied to the thread Bty34 TJ Build.Here's what I'm thinking. The 3/8" 6061 is pretty strong (2400 pounds) but deflects 2.4" with that load. It should spring back though on...
-
-
Bbty34 replied to the thread Bty34 TJ Build.When I installed the Atlas, I settled on the 15° clocking position, partially because of how high it let me shove the transmission. I...
-
-
Bbty34 replied to the thread Bty34 TJ Build.Needs a little more fine tuning, but starting to look like something. Welding in the tube made things a little harder for what seemed...
-
